If you're only using one Raspberry Pi on your network, the default be used to connect, but this will fail as you add more devices, so it's worth going with the IP address. There are many ways to do this, but the easiest is to just look in your router's settings for connected devices and locate it there. You also need to find out the IP address on your network for the Raspberry Pi. Before getting started make sure the boot microSD is inserted in the Raspberry Pi and that you power it on. Ubuntu, for example, has it out of the box, but Debian does not.įor this, we'll be using the standard Windows PowerShell. Features & Specifications of Raspberry Pi W Zero 802.11 b/g/n wireless LAN Bluetooth 4. PowerShell works just fine, but if you have WSL enabled you can also use the Linux terminal assuming you have SSH enabled in it. There was a time that you'd have to install a third-party application such as PuTTY to use SSH on Windows, but that's not the case anymore you can simply do it through the terminal.

Enable 'P3 VNC' or 'I3 VNC' (depending on version)ĭefault username and password for the Pi: username: piĭoing the above looks like: Setting up VNC on your PC Using VNC Viewer to remote to the Pi.Source: Windows Central (Image credit: Source: Windows Central).

Run sudo raspi-config to bring up the configuration menu.

Headless for VNC Setting up VNC on the Pi Enabling VNC server on the Pi.

Also in the boot partition, create a file named wpa_nf and throw the following into it (with your own Wi-Fi name and password):Ĭtrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev.

In the boot partition of the SD card create an empty file just called ssh.

Make sure you've already imaged your SD card.

rather than ejecting it by dragging it to the trash. Headless for SSH Short video on how easy it is. Setting up a Headless Raspberry Pi Zero sudo diskutil unmount /dev/disk1s1. Headless for just SSH ( skippable with v1.7 of the Raspberry Pi Imager).After writing this post, version 1.7 of the Raspberry Pi Imager released allowing you to set the headless SSH as part of the SD card imaging - essentially skipping the 'Headless for SSH' step below!

Rpi zero w headless setup